Kawasaki NINJA 74110 - Manual (Page 17)

17
Important Note: Use only a Power Wheels ® 12 volt
battery with built-in thermal fuse. Use of any other battery
will damage your vehicle. Make sure that you charge the
battery for at least 18 hours using the enclosed Power
Wheels
® 12 volt charger before operating your vehicle for
the first time. Charge the battery for at least 14 hours after
each use of the vehicle. Never charge the battery longer
than 30 hours. Failure to follow these instructions may
damage your battery and will void your warranty.
1
• Press the tab under the back of the seat and lift to remove
the seat.
• Squeeze the battery retainer arms together to release
the arms from the slots in the vehicle body.
• Press the battery retainer arms in and over the lock
tabs and lift the battery retainer.
• Lower the battery retainer over
the batteries.
• Fit the battery retainer arms down into the slots in the
vehicle body.
• Press the battery arms out over the lock tabs to snap and
secure the battery retainer arms in the slots.
• Re-assemble the vehicle seat.
• Place the battery upright in the battery compartment.
• Plug the motor harness connector into the battery. Push
firmly to join.
Vehicle
Body
Seat
Tab
Battery Installation
Battery
Retainer
Arms
Slot
2
Slot
3
Battery
Motor
Harness
Connector
Arm
Arm
Slot Slot
4
H