KORG Kaptivator KTV1 - Manual (Page 10)

8
C.Rear panel
1 2 3 4 5 6 7 8
1. AUDIO TRIG INPUT L/R jacks
These RCA-style jacks can receive line-level audio signals. The incoming audio signal can
be used for BPM detection or to control effects.
2. VIDEO INPUT jacks
These jacks can receive video signals from a DVD player or other video devices.
VIDEO INPUT 1: Receives a composite video signal.
VIDEO INPUT 2: Receives an S-video signal.
3. MONITOR OUT jacks
These jacks transmit a video signal identical to what is currently displayed by the on-board
monitor screens.
MONITOR OUT 1: Transmits the image displayed by MONITOR 1.
MONITOR OUT 2: Transmits the image displayed by MONITOR 2.
4. MAIN OUT jacks
The MAIN OUT jacks send the final output of the kaptivator, after all the internal process-
ing, mixing, etc. This is the same image that is displayed when you’ve set the MONITOR 1
SELECT setting to “MAIN”.
VIDEO: Transmits a composite video signal.
S-VIDEO: Transmits an S-video signal.
5. PAL/NTSC switch
This switches the video signal format (NTSC or PAL). You must turn off the power before
changing the setting of this switch.
6. MIDI IN / MIDI OUT connectors
You can use these jacks to connect the kaptivator to other MIDI devices - sequencers, mu-
sic samplers (e.g., ESX-1), keyboards, etc..
7. Power supply jack
Here is where you plug in the power supply. Only use the dedicated AC adapter that was
included with the kaptivator.
8. Power switch
This switch turns the power on and off. And once again, never turn off the power while the
BUSY indicator is lit. Press the NO/ESC key until the BUSY indicator goes out; then you can
safely turn the power off.