KORG Kaptivator KTV1 - Manual (Page 22)

20
Editing examples
Changing the operation of the ribbon controller
1 Select the style that you want to edit.
For this example, choose style number “04”.
2 Hold down the EDIT key and press the STYLE key. The display will indicate “A1.**” and the
EDIT key will blink.
3 Press the EDIT key several times to choose parameter B5.
Here you can choose the controller that will modify the effect. To choose the ribbon control-
ler, choose a setting in the range of “G1”–“G4.” With the “G1” setting, the effect will inten-
sify as you move the controller from bottom to top. Conversely with the “G2” setting, the
effect will intensify as you move from top to bottom. With the “G3” setting, the effect is at
maximum at either end, and minimum in the center. The “G4” setting produces the oppo-
site result, with the maximum effect in the center position.
4 When you’re finished editing, press the YES/WRITE key. Use the VALUE knob to select the
destination style location (style number) where you want to save the edited style. Then press
the YES/WRITE key to finish saving. If you decide not to save the changes you made, press
the NO/ESC key.
Changing the wipe type
1 Select the style that you want to edit.
For this example, choose style number “11”.
2 Hold down the EDIT key and press the STYLE key. The display will indicate “A1.**” and the
EDIT key will blink.
3 Press the EDIT key several times to choose parameter A2.
This parameter specifies the type of transition. Choosing “00” will specify a fade. In this ex-
ample, let’s select “03” to produce a wipe that changes the position of the images.
4 Press the EDIT key to select parameter A3.
This selects the controller that will perform the wipe operation. Choose “F1” if you want to
specify the fader. Choose “F2” if you want to invert the direction of the fader operation.
5 Press the EDIT key to select parameter A4.
This parameter specifies the type of wipe and the variable range of the controller. If you want
to create a wipe that pushes the image from left to right, specify a value in the range of “30”–
“39.” The second digit of the value specifies the range of fader movement. In this case, se-
lecting “30” will produce a wipe using the entire range of the fader. Selecting “35” will wipe
using half the range of the fader. Selecting “39” will cause the image to switch at the mid-
point of the fader.
6 When you’re finished editing, press the YES/WRITE key. Use the VALUE knob to select the
destination style location (style number) where you want to save the edited style. Then press
the YES/WRITE key to finish saving. If you decide not to save the changes you made, press
the NO/ESC key.