Kodak INNOVATION I100 - Manual (Page 19)

16 A-61514 September 2004
Input and output trays
The input and output trays snap into place. They also may be adjusted to fit
different document sizes. The input and output trays also may be folded flat up
against the scanner to save space when the scanner is not in use.
Attaching the input tray 1. Locate the input tray slots (large holes) on the scanner.
2. Align the input tray pins with the slots.
3. Press the input tray until it snaps into place.
NOTE: Opening the scanner door may make it easier to see the slots and align
and install the tray.
Attaching the output tray 1. Locate the output tray slots on the scanner.
2. Align the output tray pins with the slots.
3. Press the output tray until it snaps into place.
Tray extenders and
side guides • Both the input and output trays have extenders to accommodate long
documents. Grasp the tray extender and pull it out to the desired position.
• The output tray has 3 document stops that can be raised to accommodate
the collection of small documents after they have been scanned.
• The input tray has side guides that allow you to adjust the feeder to fit
different document sizes. Grasp the side guides and slide them to the
desired position.
Input tray Output tray
Output Input tray extender
tray extender Document
stops