Kodak INNOVATION I100 - Manual (Page 29)

26 A-61514 September 2004
Cleaning the paper path 1. Remove the wrapping from the Transport Cleaning Sheet.
2. Adjust the paper feeder guides to fit the cleaning sheet.
3. Feed the cleaning sheet (adhesive side up) through the scanner in portrait
orientation until all residue is removed from the drive rollers.
4. Adjust the feeder guides to fit, then feed the cleaning sheet (adhesive side
up) through the scanner in landscape orientation until all residue is
removed from the drive rollers.
5. Using the same cleaning sheet, repeat Steps 3 and 4, but feed the
cleaning sheet through the scanner with the adhesive side down until all
residue is removed from the drive rollers.
NOTE: When a cleaning sheet gets very dirty, discard it and use a new one.
Replacing parts
Customer-replacement parts (feed module, separator module, pre-separation
pad, roller tires, imaging guides) and installation instructions are available in
the following kits:
Use only these replacement parts in your scanner.
The expected life of customer-replaceable parts is shown below.
• Kodak Separator Module for i100 Series Scanners:
200,000 document pages
• Kodak Feed Module for i100 Series Scanners:
500,000 document pages
• Kodak Image Guides for i100 Series Scanners:
replace when guides are scratched or damaged
NOTES: The composition of the roller materials was engineered to provide the
ultimate in feeding reliability across the broadest range of document
types, sizes, and thicknesses. Expected life figures are offered as
guidelines for operations that follow the recommended scanner
cleaning procedures in this section and that scan document types
within the recommended paper types (refer to “Preparing Documents
for Scanning” in the Introduction section).
Your experience may vary. Certain paper types (such as carbonless
paper or newsprint), failure to clean regularly, and/or use of non-
recommended cleaning solvents can shorten roller life.
To order replacement parts, refer to Appendix B, Supplies
and Accessories.
Item CAT No.
Kodak Feeder Consumables Kit for i100 Series Scanners (1
complete feed module, 1 complete separator module, 2 pre-
separation pads, 24 roller tires) 124 1066
Kodak Extra-Large Feeder Consumables Kit for i100 Series
Scanners (5 complete feed modules, 5 complete separator
modules, 10 pre-separation pads, 120 roller tires) 821 5808
Kodak Imaging Guide Set (1 upper guide, 1 lower guide) 120 0278
Calibration Target (12” x 12”) 127 1436
Kodak White Background Accessory 829 3599