Kenwood DT-7000S - Manual (Page 9)

the presets. Each time you change a preset its number will appear on the
display and the stream will play.
Option 2: Press the ENTER button. The
Preset List Screen will
appear on the display, listing
all of the stream presets
that have been programmed
in all 4 banks (right)
• Use the CH./PRESET jog dial
(front panel) or CH Buttons
(remote) to scroll through
the list. When the desired
stream is highlighted on the
display, press the ENTER button to select it.
Naming preset banks
You can personalize the four banks of
stream presets by assigning a name
(up to 6 characters) to each one.
For example, you can set up different
preset banks for family members
(‘Dad’, ‘Billy’, etc.), or assign a
particular type of music to each one
(‘Mellow’, ‘Party’, etc.).
Note: Although you can use the
corresponding buttons on the unit to
name the banks, it is simpler to use
the remote.
1. Press the SETUP button to enter the
Setup Mode.
2. Press the CAT buttons until the Bank
Name Input screen appears (top, right).
3. Press the CH button once. The Bank
Select screen will appear (second,
right). Use the 4 arrow buttons to
highlight the bank you want to name.
4. Press the ENTER button. The Bank
Naming screen will appear (above). Press the DELETE button multiple times to delete
all the letters of the existing name. (Note: There is no DELETE button on the unit.)
5. Press a number button multiple
times to select the letters you want
(right). When the letter you want is
highlighted, press the ENTER button.
The letter will appear in the name.
• To add spaces, press the SPACE
button. (Note: There is no SPACE
button on the unit.)
• If you make a mistake, use the CH
buttons to move the cursor to the left
of the letter you want to delete, and
press the DELETE button.
6. Repeat Step 5 to complete the name
(top, right).
7. Press the ENTER button to save your
choice (second, right).
Press the SETUP button twice to exit
the Setup Mode.
Saving/recalling music information
Saving music information
You can store the name of the current-
ly-playing song and artist (and compos-
er, if the data is available) into memory
for recall later.
Press the MEMO button to save the
data. The Data Saved screen will
display the following message for a few seconds (above):
• You can save data for up to 24 songs. Once all 24 places have been filled, any new
artist/song data you save will replace the oldest data.
• If the song has already been stored in memory, the display will read “Already Stored”.
Recalling music information
1. Hold the MEMO button for more
than 1 second. The Song Memory
List screen will appear (right):
2. Use the CH./PRESET jog dial or CH
buttons to scroll through the list.
Press the MEMO button to exit.
Activating Song Seek
You can have the DT-7000S auto-matically prompt you when any of the songs saved on
the Song Memory List is playing on any
stream.
1. Activate the Song Memory List
screen (see previous section).
2. Use the CH./PRESET jog dial or CH
buttons to scroll through the list of
saved songs until the one you want is highlighted.
3. Press and release the ENTER button. An “S” will appear next to the song’s name (above).
Press the MEMO button to exit.
Preset List Screen
Song Memory List Screen
Song Seek Icon
Data Saved Screen
DT-7000S Instruction Manual 9
Bank Name Input Screen
Bank Select Screen
Bank Naming Screen
Selecting letters
Completed name
Saved name