Kodak DCS300 - Manual (Page 92)

6-2
The following table lists the functions available in each mode.
.
* Setting BASIC mode, then returning to ADVANCED mode reactivates the previously
set mode/functions.
** The ISO icon means ISO 200.
☛
Camera settings are saved when you capture an image or the camera enters PowerSave mode.
Functions/
modes
In BASIC mode In ADVANCED mode Refer to
Vari-Program Six options are selectable Page 6-3
Exposure mode*
(excluding Vari-
Program) Fixed at Auto-Multi
Program Auto-Multi Program, Shutter-Priority
Auto, Aperture-Priority Auto and Manual
are selectable Page 6-10
Metering system* DCS 315: Fixed at
Center-Weighted
DCS 330: Fixed at
Matrix DCS 315: Center-Weighted and Spot are
selectable
DCS 330: 3D Matrix, Center-Weighted
and Spot are selectable Page 6-27
Focus area/AF
mode* Fixed at Wide with
Single Servo AF Wide with Single Servo AF, Wide with
Continuous Servo AF, Spot with Single
Servo AF, and Spot with Continuous
Servo AF are selectable Page 6-30
Drive mode* Fixed at Single-
Frame Single-Frame and Continuous are
selectable Page 6-39
Flash Sync mode* Fixed at Normal
Sync Normal Sync, Red-Eye Reduction, Red-
Eye Reduction with Slow-Sync, Slow
Sync and Rear-Curtain Sync are selectable Page 8-4
ISO** Fixed at ISO 200 Manual available Page 7-15
Flexible Program Available Page 6-17
AE lock button Available Page 7-4
Self-timer Available Page 7-1
Built-in flash Available Page 8-9
Two-Button Reset Not available Available Page 6-41
Exposure
Compensation* Not available Available Page 7-3
Flash Output Level
Compensation* Not available Available Page 8-20
Auto Exposure
Bracketing Not available Available Page 7-9
Flash Exposure
Bracketing Not available Available Page 8-16
QR (Quick Recall) Not available Available Page 7-12
A