Kambrook KI400 - Manual (Page 7)

7
Table A
linen
NOTE:
Label Code
[see garment
instruction]
Kind of Textile
synthetic
modacry
polypropylene
polyurethane
acetate
triacetate
matalized
cupro
plyamide [nylon]
polyester
modal
viscose [rayon]
silk
wool
cotton
Temperature
Control
MIN
DRY
MIN STEAM
MAX STEAM
LINEN
MAX
Variable Steam
Control
[advised position]
on label means: “This article cannot be ironed”
[e.g. chlorofibre, acrylic, elastodiene]
Before First Use
Remove any promotional material or
packaging from the iron.
Remove any sticker or protective cover
from the soleplate. When operating the
iron for the first time, iron on an old piece
of fabric to ensure that the soleplate and
water tank are completely clean.
When the iron is used for the first time,
some vapour may emit. After a short
while however, this will cease. The
vapour is due to the initial heating of
the materials used in the iron. It is safe
and will not harm the performance of
the iron.
NOTE: As an important part of
our quality control process, your
iron has been individually tested.
As a result, you may notice a
small amount of condensation
or water droplets on the inside of
the water tank. There is no need
for concern.
Setting the Temperature
Before commencing ironing, first sort
the items to be ironed according to the
International Textile Care Labelling Code
or by the type of fabric. Iron fabrics
that require the lowest temperatures
first. Work through to the fabrics
requiring higher temperatures. Both the
Temperature Control and most items of
laundry have markings corresponding
with this code (see Table A).
Operating Instructions
KI400_KI460_IB_D12.indd 7 5/12/12 12:05 PM