Scanning photos for editing – Lexmark 4900 Series User Manual
Page 91
4
From the “What is being scanned?” menu, choose the type of document to be scanned.
5
Click Scan.
6
Follow the instructions on the computer screen.
Scanning color or black-and-white original
documents
1
Load an original document faceup into the Automatic Document Feeder (ADF) or facedown on the scanner glass.
Notes:
•
Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine
clippings) into the ADF. Place these items on the scanner glass.
•
Adjust the paper guide on the ADF tray to the width of the original document.
•
When using the scanner glass, close the top cover to avoid dark edges on the scanned image.
2
From the printer control panel, press .
Scan to menu appears on the display.
3
Press the up or down arrow button to choose where to send the scanned image. You can send the scanned image
to a computer, flash drive, memory card, or to a computer over a network.
4
When the destination that you want is highlighted, press OK.
5
To scan black-and-white documents, press
.
Note: The default setting when you are using the Scan mode is Color. You do not need to press
if you
are scanning a color document.
6
Press .
Scanning photos for editing
1
Open the top cover, and then load an original document facedown on the scanner glass.
2
Close the top cover to avoid dark edges on the scanned image.
3
From the printer control panel, press .
4
Press the up or down arrow button until Computer is highlighted, and then press OK.
Notes:
•
If you choose to send the scanned image to a computer over the network, press the left or right arrow button
until the computer name of the network computer appears, and then press OK.
•
You may be prompted to enter a PIN if the computer requires it. To assign a computer name and a PIN to the
network computer, see the Help for the printer software associated with your operating system.
•
If your printer has a numeric keypad, enter the PIN using the keypad, and then press OK.
•
If your printer does not have a numeric keypad, use the left or right arrow button to decrease or increase the
value for each digit (the default value is 0000) in the PIN, and then press OK each time you select a digit.
Scanning
91