Logitech Transporter SE: Network Music Player 930-000011 - Manual (Page 10)

 Logitech®
Configuring Transporter
The instructions below use the remote control to set up Transporter. You can also
use the front panel controls. To scroll up and down, turn the knob on the front panel.
Pressing the center of the knob is equivalent to pressing the RIGhT arrow on the remote.
Pressing the BACK button on the front panel is the same as pressing the LefT arrow.
The other buttons on the front panel are the same as the corresponding buttons on the
remote.
When you plug in Transporter, the Slim Devices logo is displayed briefly, followed by a
welcome message.
Set Up Networking
1. Press the RIGhT arrow on the remote control. The Set Up Networking menu
option is displayed.
2. Press the RIGhT arrow to enter networking setup.
3. Choose whether you want to connect Transporter to a wireless or wired network
by pressing the UP and DOWN arrows on the remote. When you have made your
selection, press the RIGhT arrow. If you are using an ethernet connection, skip to
step 7.
4. Transporter prompts you for your local region or country. Scroll using the DOWN
arrow on the remote until you find the local region. Press the RIGhT arrow to
select your region.
Note: Failure to select the appropriate region may violate local laws.
5. Transporter will scan to find your wireless network. Select your network name
(SSID) and press the RIGhT arrow.
If you are in an area where there are multiple wireless networks, you can scroll
down using the remote until you find the one you want to use. If your router is
not broadcasting your network name, you will need to select “Enter a network
name”.
Tip: You can use the number buttons on the remote to enter text as you might
on a cell phone. Use the PLAY button on the remote as a backspace and the ADD
button to insert a letter.
6. If your network is secured with WEP or WPA encryption, you’ll need to enter the
network password or key using the numbers and letters on the remote and press
the RIGhT arrow. If your network supports more than one type of encryption at a
time or is not broadcasting its SSID, Transporter may first ask you to choose your
encryption method.