Logitech Transporter SE: Network Music Player 930-000011 - Manual (Page 11)

 Transporter™ Owner’s Guide
Tip: WEP keys consist of a string of ten or twenty-six digits or letters A through F.
WPA passwords are a string of letters, numbers or punctuation.
Enter the subnet mask for the network, the default gateway IP address, and the
address of your DNS server, pressing the RIGhT arrow on the remote to move to
each one.
Tip: If you are having trouble connecting to your wireless network, check the
Frequently Asked Questions section at the end of this guide.
Select a Music Source
1. If SlimServer isn’t already running, start it now.
Transporter will scan your local network to find the computer that’s running
SlimServer. If you started SlimServer after configuring Transporter, you may need
to scroll to find it.
Tip: If SlimServer is running on your computer and you don’t see it in this menu,
check the Troubleshooting section at the end of this guide and make sure that
any firewall software you have installed is configured properly.
You can also choose to connect to the SqueezeNetwork internet service. See the
SqueezeNetwork section of this guide for more information.
2. Select the computer you want to use. If you are running SlimServer on multiple
computers on your local network, you can use the DOWN arrow to scroll to the
one you want to use.
3. Press the RIGhT arrow on the remote to connect.
Setup is complete.
Tip: If you want to go back to setup later press the LefT arrow on the remote
down and hold it for five seconds. Transporter will return to the Set Up
Networking menu.