Logitech Transporter SE: Network Music Player 930-000011 - Manual (Page 22)

0 Logitech®
Press DOWN to see Alarm Clock Off. Press RIGhT to turn on the alarm. Press
RIGhT again to turn it off.
To set alarms using the web interface:
1. Open the SlimServer web interface and click on Player Settings for the player.
2. Click on the Alarm tab on the top left area of the page.
3. Use the form to choose which alarms you’d like to set, the time you’d like them
to go off and what playlist you’d like to hear when the alarm goes off. Click
Change to save your choices.
Once you’ve set the alarms you like, your Transporter will wake up on the day and time
you’ve set and start playing.
Tip: You can set unique alarm times for each day of the week under the
additional weekday setting.
Graphic Visualizers
Transporter can display graphic visualizers such as spectrum analyzers and VU meters
that beat to the music as it’s playing. You can choose to show visualizers on the display
all the time or as a screensaver.
Press the VISUAL button on the front panel to rotate through the different visualizers
which are displayed on the right side of the display.
To choose a graphic visualizer to display as a screensaver:
1. Under settings, choose Player Settings, then scroll to Screensavers.
2. Choose from the list of screensavers.
Using Transporter as a Wireless Bridge
Transporter has both 802.11g and ethernet connections. You can easily connect non-
wireless devices (such as a TiVo, PlayStation, XBox, or a home theatre PC) to your wireless
network. To set up Transporter as a wireless bridge:
1. Plug the device that you want to connect to your wireless network into the
ethernet port on the back of Transporter using an ethernet crossover cable. You
can purchase a crossover cable at most retail computer stores.
2. Press and hold the LefT arrow on the remote for five seconds to enter the
Transporter setup screens.
3. Press UP to scroll to the Set Up Networking selection and press RIGhT .
4. Go through the network setup screens, choosing to connect to a wireless
network and then select your region.
5. You are presented with the option to turn on wireless bridging. Select Yes and
then press RIGhT .