Lucent Technologies MDW 9030P - Manual (Page 3)

Handset Display
MSG ON RANGE MUTE
1
2
8
7
6
9
5 4 3
Each line status indicator corresponds to a specific outside line or
programmable/intercom/drop button:
PARTNER Systems
A triangle ( ) is the equivalent of a green LED on a wired phone.
A rectangle ( ) is the equivalent of a red LED on a wired phone.
All Other Systems
A triangle ( ) is the equivalent of a red LED on a wired phone.
A rectangle ( ) is the equivalent of a green LED on a wired phone.
Line Status Indicators
1 Information you would see on a wired system phone's display,
(except time), based on your communications system:
LCL:P, D, M1, or M2 = Local Mode:communications system
WIRELESS TEST =Handset in Wireless Test Mode
VIBR =Vibrator enabled
PSEL =Line Preselection enabled
PRESELECTION:ON / OFF =Line Preselection Mode:status
CHANGE BUTTN MAP =Communications system setting is wrong
MAP:P, D, M1, M2 =Button Mapping Mode: setting
NO LINK =Handset is not communicating with radio module
2 MSG indicates that you have a message.
3 RANGE indicates that the handset is out of range or almost out of
range. Handset also beeps.
4 ON indicates that handset was turned on by pressing O .
5 Battery icon flashes to indicate a low battery condition. Handset
also emits 2 beeps.
6 No Ring icon indicates that the alerter is disabled.
7 MUTE indicates that handset microphone was turned off by
pressing M.
8 Line Status Indicators show the status of line or programmable/
intercom/drop buttons. See "Line Status Indicators" below.
9 Selection rectangle indicates the active row for line or program-
mable/intercom/drop button selection.
When the display is blank, the handset is either turned off or in "sleep"
mode. Activate the display by pressing O or ".
- 2 -
9030P QuickRef Fin. Drft. 2/7/97, 1:27 PM 4