Lucent Technologies MDW 9030P - Manual (Page 5)

Making a Call
1. Press O.
2. If desired, press " to move the Selection rectangle; then press '
corresponding to the line you want.
3. Dial the call.
4. To end the call, press O.
Answering a Call
1. Press O.
2. Speak into the handset.
3. To end the call, press O.
Once Line Preselection is enabled, proceed as follows:
1. If the display is blank, press ".
2. If necessary, press " to move the Selection rectangle.
3. Press ' corresponding to the line or button you want.
4. Press O to access the line or button.
Preselecting a Line or Button
Changing Settings or Performing Tests
in Local Mode
1. Make sure the handset is turned off.
2. Press and hold " for 3 seconds.
3. While still holding ", press O.
4. Press one of the following:
A (2) to enable or disable the alerter.
P (7) for 3 seconds, then " to enable or disable Line Preselection.
V (8) to enable or disable the vibrator.
W (9) to enter Wireless Test Mode, then
1 for signal strength
2 for voice quality
3 for matching radio module and slot number
# to enter Local Test Mode.
5. Press O to exit.
- 4 -
! CAUTION:
The MDW 9030P handset is a radio device and, like all radio
devices, should not be placed next to a pacemaker. See
"Guidelines for Safe and Efficient Operation" in MDW 9030P
Wireless Pocketphone Installation and Use for more information.
PARTNER, MERLIN, and MERLIN LEGEND are registered trademarks of
Lucent Technologies.
Lucent Technologies 503-801-161
Comcode 107993149
Issue 2, March 1997
Copyright © 1997 Lucent Technologies
9030P QuickRef Fin. Drft. 2/7/97, 1:27 PM 2