Lucent Technologies MDW 9030P - Manual (Page 4)

Volume Adjustment
To increase or decrease the volume of the handset alerter or the
receiver (earpiece):
■ Alerter: Press the " + " or the " – " button while the MDW 9030P
is awake but turned off. If the display is dark (the phone is in
"sleep" mode), press " to wake it up, then press the " + " or
the " – " button.
■ Receiver: Press the " + " or the " – " button while the MDW
9030P is turned on.
Battery Charger LEDs
The color of the battery charger's LEDs indicates the state of the
corresponding battery pack, as shown in the following table:
If you need help when using your MDW 9030P with a PARTNER,
MERLIN
® , or MERLIN LEGEND ® system in the continental U.S.,
call 1 800 628-2888. For all other systems, follow the procedure
you normally use to get support for your communications
system. Outside the continental U.S., contact your Lucent
Technologies Representative or local Authorized Dealer.
Help!
Battery
charger
LED shows...
If it is the SPARE
LED, the battery
pack in the Spare
battery
compartment...
If it is the
HANDSET LED,
the battery pack in
the Handset...
If it is the
REFRESH LED,
the Refresh button
was pressed, and
the Handset
battery pack...
Steady
orange Is charging Is charging N/A
Steady green Is fully charged Is fully charged N/A
Flashing red
* See note.
Has one of the
following problems:
• Is not seated
properly in the
charger
• Has dirty
contacts
• Is defective
Has one of the
following problems:
• Is not seated
properly in the
charger
• Has dirty
contacts
• Is defective
N/A
Steady red Is in the Discharge
portion of the
Refresh cycle. Is in the Discharge
portion of the
Refresh cycle. Is in the Discharge
portion of the
Refresh cycle.
*Note: If either the SPARE LED or the HANDSET LED is flashing red, both
battery packs must be removed from the charger to clear the flashing-red
condition. Address the possible problems for one battery pack at a time to
determine whether one is bad.
- 3 -
9030P QuickRef Fin. Drft. 2/7/97, 1:27 PM 5