Lyngdorf Audio MkIV - Manual (Page 11)

- 11 -
Mute
When "Mute" is activated from the remote control the display shows "---" and the amp will
be muted. Press the "Mute" button again to deactivate the mute status. If the volume is
changed when Millennium is muted, the display will show the volume for 3 seconds.
Advanced Set-up
Check the mains voltage
Attempting to operate the Millennium at an incorrect voltage can damage the unit! Power
is supplied via the lEC-connector on the back panel. Neither the voltage nor the line
frequency setting may be changed by the user. Make sure that the label on the rear panel
of the Millennium indicates the correct AC operating
voltage for your country.
When the power switch (1) is pressed - the standby circuitry, which controls the mains
relay will be activated. The amplifier will start in standby mode indicated by the red
Lyngdorf logo. After a few seconds, the amplifier can be switched into operational mode by
pressing any of the two input selector (2 or 4) buttons or using the power button on the
remote control. In operational mode, the display located in the wheel will be visible to bring
the amp back to standby mode, press the power button on the remote or press the input
selector buttons simultaneously for 2 seconds. This will also default the volume setting
(See section on volume control).