Lyngdorf Audio MkIV - Manual (Page 16)

- 16 -
Connectors
Mains Connector
Mains voltage to the Millennium is applied via an IEC320 type connector. The supplied
cable with safety ground should be used to connect the Millennium to a mains outlet.
WARNING: Connect the power input only to the AC source printed on the
label. The warranty will not cover any damage caused by connecting to the
wrong type of AC mains.
WARNING: Always disconnect the Millennium from the mains before
changing any connections to its inputs or outputs.
Loudspeaker connectors
The Millennium’s loudspeaker connectors accept bare wire ends up to 5 mm in diameter.
Connect the wires from each loudspeaker to each channel's + and – terminals. Do not
make any other connections to the output terminals. The loudspeaker cable is inserted into
the slot in the loudspeaker terminal, and the terminal is tightened firmly.
WARNING: Always disconnect the Millennium from the mains before
changing any connections to its inputs or outputs.
WARNING: Make sure that no conductive part of the speaker wiring is
accessible. Do not connect loudspeakers with uninsulated terminals.
When the Millennium is operating, there is up to 35V DC on its output terminals with
reference to ground.
Do not connect the output from the amplifier to any other amplifier's output
or any other voltage source. Do not attempt to operate the amplifier in
bridged mono mode.
Cleaning and maintenance
Always unplug the unit from the electrical outlet before cleaning.
This unit does not require any regular maintenance except to keep its exterior clean.
Simply wipe its exterior with a clean soft cloth. A small amount of non-abrasive cleaner
may be used on the cloth to remove any excessive dirt or fingerprints. Do not use abrasive
cleaners or cleaners containing liquid solvents.