Lanier LASER 200 - Manual (Page 14)

LANIER
– 1 /3 rd S ca le La ser 2 0 0 A R F -
INSTRU CTIO NS
© 2002 Lanier R/C Page -14
88. Secure the tank in the fuse w ith cable ties
through holes in the fuse floor.
89. Install your fuel line on the end of the tank lines
to the m uffler pressure and carburetor fittings.
M ake sure to allow enough extra line to the
needle valve line to give access for filling.
90. Locate the holes for the ccockpit screw s and
rem ove any covering w ith a sharp knife.
91. Test fit the cockpit cover and 4 m m flat head
screw s.
92. Trim the clear plastic canopy ¼” from the
scribed line, then test fit on the fuselage. Trim if
needed. W ash the canopy out w ith cool w ater
and dish detergent, then dry w ith a paper tow el.
93. N ow is the tim e to install any cockpit details,
such as dashboards or pilots (N O T
IN CLU D ED ). Secure them firm ly in the cockpit
w ith epoxy.
94. Install the canopy on the fuselage w ith epoxy or
“goop”. H old in place w ith tape until cured.
95. W ith your engine fully set up, now reinstall the
cow ling and fasten in place w ith the cow l
screw s. Install your prop and 4” spinner. (W e
recom m end Tru Turn spinners.
)
96. Tem porarily place your battery and receiver in
the fuse, then install the w ing. Y ou w ant the
plane to balance on the w ing tube center.