Lanier LASER 200 - Manual (Page 3)

LANIER
– 1 /3 rd S ca le La ser 2 0 0 A R F -
INSTRU CTIO NS
© 2002 Lanier R/C Page -3
radio. C enter the servo by hooking it up to the
proper channel of your radio and centering the
trim tabs.
9. Install your servo horn so that it is protruding the
hole of the plate and install the servo horn screw .
10. U se a piece of m usic w ire or w ooden dow el to
help feed the servo w ires through the w ing. Y ou
w ill need to add extensions to the aileron servo
w ires to reach into the fuselage.
11. Fasten the servo plate to the hardw ood plate rails
in the w ing w ith (4) #4 x ½ ” screw s (dubro
#382)
12. Locate the Sullivan aileron hardw are, (2)2 7/8” long
4-40 rods, (4) clevis, (2) couplers, (2) m achined
nuts, and (2) 8-32 long” screw s. Trim
and thread
the rods as needed. Install a clevis on the end of
each rod.
13. Install a (4) arm servo w heel on the servo
tem porarily, m aking sure it is parallel to the
w ing. Locate the hard points in the ailerons, and
pierce the covering w ith a sharp hobby blade.
Install the (2) aileron control horn screw s from
the top of the w ing, dow n through the aileron.
Secure the bolt w ith the m achined nut, and
thread lock. Install the (2) couplers on the
control horn bolts until the threads just show
from the tops. H ook the links to the aileron
couplers and lay the rods across the servo arm .
14. Install the tw o clevis on the ends of the 4-40 rod.
A lign the aileron on the w ing and hold in
position w ith a sm all piece of tape. A djust the
clevis to the proper length, then install on the
servo and coupler. U se red thread lock w hen
adjusted, then install the clevis keeper.