Lanier LASER 200 - Manual (Page 9)

LANIER
– 1 /3 rd S ca le La ser 2 0 0 A R F -
INSTRU CTIO NS
© 2002 Lanier R/C Page -9
53. Placethe fiberglass cow l on the fuse and fasten
w ith the 4m m screw s through the holes. The flat
head screw s go in the top end of the cow l.
M easure from the engine crank hole to the first
form er surface w ith a ruler. W rite dow n the
length.
54. N ow m easure the length of your m otor w ith the
m otor m ount installed, from the front of the prop
backing plate to the rear of the m ount. Subtract
¼” from this length (for prop clearance of the
cow l).
55. Subtract the m otor m easurem ent from the cow l
m easurem ent. This w ill be the distance the
firew all needs to be from the first form er. U se a
ruler and straight edge to m ake a 90 degree line
on the fuse sides w here the firew all should be
installed.
56. G lue the firew all in the fuse at the m arks you just
scribed. U se 30 m inute epoxy and clam p in
place until cured.
57. A djust the length of the ¼ ply low er so the
beveled edge is even w ith the front of the
firew all. Rem ove the covering from the bottom
of the firew all form ers to allow glue to penetrate,
and epoxy the plate in place. Clam p in place
until cured.
58. W hen all is cured, cut the fuse sides flush w ith
the firew all.
59. A djust the length of the engine box doublers,
then glue in place w ith w hite glue or epoxy.
Clam p until set.