LevelOne FPS-2013TXU - Manual (Page 25)

Level One Printer Servers
Menu Options
Status Menu
Device Info Same as Device button.
Display all the configuration and status information about the
selected LevelOne Printer Server. The data is presented in a
scrolling, read-only window.
Port Same as Port Status buttons.
InitDevice Menu
Attach Remote This is used to connect to a LevelOne Printer Server device on
another LAN segment. If your LAN does not have a Router, ignore
this option.
Connected
Protocol This option allows you to designate which LAN protocol will be
used for communication between the selected device and this
application. You should select ONE protocol only.
Find Use this option to use the IPX/SPX protocol to locate a LevelOne
Printer Server on the LAN. Simply enter the Default Name of the
LevelOne Printer Server you wish to locate. The Default Server
Name is shown on a sticker on the base of the device.
Reset Device This will cause the device to reboot. This should be done after
making any configuration changes, or if the device stops responding
after some problems.
Restore Factory
Default This will restore ALL device values to their factory defaults. To
restore only the current screen, use the Set to Default button on the
screen.
Set IP Address For TCP/IP networks only:
• If a LevelOne Printer Server does not appear on the main
screen, use this option to set a Device IP Address, Gateway IP
Address, and Network Mask to the LevelOne Printer Server.
• This should only be necessary if your LAN is using ONLY the
TCP/IP protocol. In other cases, BiAdmin will use IPX/SPX to
locate the LevelOne Printer Server even if it doesn't have a
valid IP Address.
• To locate the LevelOne Printer Server, enter the Default Name.
The Default Server Name is shown on a sticker on the base of
the device.
• Enter the required IP Address, Network Mask, and Gateway IP
Address.
• After saving the data to the device, refresh the listing. The
LevelOne Printer Server should then appear in the device list on
the main screen.
Upgrade Upgrade the firmware in a LevelOne Printer Server. See Upgrade
Icon for details.
- 22 -