LevelOne FPS-2013TXU - Manual (Page 5)

Level One Printer Servers
Safety Instructions
For your own safety, and to protect your LevelOne Printer Server, please observe the
following safety advice.
1. Unplug this device from its power source before cleaning. Use only a slightly
dampened cloth for cleaning. Do not use liquid or aerosol cleaners.
2. Avoid using this product near water. Exposure to water poses an electric-shock hazard.
3. Do not place this device on an unstable surface. The device may fall causing serious
damage to the device.
4. This device should only be used with the power supply type specified on the marking
label. If you are not sure of type of your local power supply, consult your dealer or
local power company.
5. Do not pinch, crimp or otherwise damage the power cord. If exposed to foot traffic,
ensure that the cable is properly shielded and does not pose a tripping hazard.
6. If using an extension cord, make sure the total ampere rating of the products using the
cord does not exceed the extension cord’s ampere rating.
7. Do not attempt to service this device, as opening or removing casing may expose you
to dangerous voltage points or other risks. Refer all servicing to qualified service
personnel.
8. The device should be serviced by qualified service personnel under the following
conditions:
• The power cord is damaged or frayed.
• Liquid has been spilled onto the product.
• The product has been exposed to rain or water.
• The product does not operate normally in accordance with the operating
instructions.
• The device has been dropped or the casing has been damaged.
- 2 -