Lucent Technologies P115G - Manual (Page 10)

Chapter 2 Installation
Cajun P115G Stackable Switch Installation Guide 9
Figure 2 Rear View of a Cajun P110 Stack, Showing how the Units are linked via the
Cajun P110 Exoplane Cables. A Cajun P110 NMA Resides in the Uppermost
Unit.
6. Two terminators are supplied with the Cajun P110 NMA. Insert the two
terminators into the lowest two connectors at the bottom of the stack, as shown in
Figure 2.
7. Turn on the mains power to the stack, by individually plugging in each hub.
8. Connect the cables to the front panel ports.
Notes:
•
If the Cajun P110 NMA in the stack contains software version 8.4 or higher, the
stack is now fully operational.
•
When a new version of the Cajun P110 NMA software becomes available, you
should perform software download to benefit from the extra capabilities
provided. See the Cajun P110 NMA Installation Guide for details.
Note: When a Cajun P110 switch is added to, removed from or swapped in a stack,
all Ethernet port settings (Administration Status, Port Mode, port speed and VLANs)
will return to their default values.