Lucent Technologies P115G - Manual (Page 7)

Chapter 2 Installation
6 Cajun P115G Stackable Switch Installation Guide
•
100M 1-8, 100M 9-16, and 100M 17-24: Selects whether the port groups will
operate at 10 Mbps or 100 Mbps.
•
100M: Selects whether the copper uplink port will operate at 10 Mbps or
100 Mbps.
•
FDX: Selects whether the uplink will operate at full or half duplex mode.
Note: FDX with Flow Control is supported for the uplink port only when a Cajun
P110 NMA is present.
•
FX: Selects whether the uplink is through a fiber-optic line or a copper line.
Note: Only the Ethernet uplink port can operate in full duplex mode. The 24
individual ports can only be used in half duplex mode.
Table 1 DIP Switches on the Cajun P115G Stackable Switch
Switch Function ON OFF
USE SW
(Use Switches) Selection of operational mode:
control by management
station or DIP switches. Ignore
management
settings.
Use switches. Use management
settings.
Ignore switches.
100M 1-8,
100M 9-16,
and 100M
17-24 Switches Selection of port speed 100 Mbps 10 Mbps
100M Selection of uplink speed for
copper port only. 100 Mbps 10 Mbps.
FDX Selection of uplink Half/Full
Duplex mode. Full duplex Half-duplex
FX Selection of fiber optic or
copper line on uplink port. Fx Tx
(right-most
switch) Not used
The shaded cells show the default settings for the DIP switches.
Once you have set the switches, you may proceed with the physical installation of the
hub.