Lucent Technologies P115G User Manual
Page 11
Chapter 2 Installation
10
Cajun P115G Stackable Switch Installation Guide
Rack Mounting
Cajun switches slot into a standard 19 inch rack.
Remove the rubber legs from the base of any switch that is to be rack mounted.
Place the switches in the rack, as follows:
1. Snap open the ends of the front panel to reveal the fixing holes.
2. Insert the switches into the rack so that the switches in a logical stack lie directly
on top of each other. Ensure that the Cajun screw holes are aligned with the rack
hole positions exactly as shown in figure 3. Stacking them in this way will allow
the switches to be easily connected using the Cajun P110 Exoplane cables.
3. Secure the switches in the rack using the screws. Use one screw on each side. Do
not overtighten the screws in order not to damage the plastic.
4. Connect the Cajun P110 Exoplane cables, as described above, and as illustrated in
Figure 2.
5. Snap closed the hinged ends of the front panel.
Figure 3
Cajun rack mounting arrangement