Braun 1013 - Manual (Page 3)

4
Our products are engineered to
meet the highest standards of quality,
functionality and design. We hope
you thoroughly enjoy your new Braun
appliance.
Important
Keep the shaver and the mains lead
dry at all times. Do not handle with
wet hands. Do not store in a damp
environment. To avoid damage do
not wind the mains lead around the
appliance. It is important to check the
mains lead for damage periodically
particularly at each end where the
mains lead enters the plug.
Description
1 Socket for the mains lead with
voltage selector
2 «On/off» switch
3 Longhair trimmer switch
4 Pop-out longhair trimmer
5 Cutter block
6 Shaving foil frame
7 Foil protection cap
8 Cleaning brush
Connection
115 V (110 V … 120 V)
230 V (220 V … 240 V)
Set the voltage correctly (115 V or
230 V) at the bottom of the shaver
1
(a). Only connect to ac (~).
Shaving
Remove the foil protection cap 7 (b).
Push «on/off» switch 2 up to «on».
Hold the shaver at right angles to your
skin. Stretch your skin with your free
hand (c). Guide the shaver smoothly
against the direction of beard growth,
applying only gentle pressure.
Longhair trimming
To use pop-out longhair trimmer 4 ,
push switch 3 all the way up to setting
«longhair trimmer».
The longhair trimmer allows easy and
exact trimming of the side burns (d).
The longhair trimmer can be switched
on and off during shaving.
Switching the shaver off
Push the «on/off» switch 2 back all
the way to setting «off».
Important: After every shave replace
the foil protection cap
7 on the foil
frame 6 .
Cleaning and maintenance
After every shave, remove the foil
frame
6 (e) and tap out lightly. Brush
out the cutter block 5 with the clean-
ing brush 8 (f). Do not clean the
shaving foil 6 with the cleaning
brush to avoid damaging it. Approxi-
mately every four weeks clean the
space between the longhair trimmer
4 and the shaver with the cleaning
brush 8 .
Clean the cutter block 5 with Braun
cleaning spray to maintain your
shaver’s top shaving performance
and to keep it hygienic.
After every cleaning replace the foil
protection cap
7 on the foil frame 6 .
Changing the shaving parts
The shaving foil frame 6 should be
held at the two grooved surfaces and
pulled off (e).
The cutter block 5 can be removed
(e.g. for cleaning) by turning it at right
angles to the shaver and lifting it off
English
5462063_1008-13_S4-30.fm Seite 4 Freitag, 24. August 2001 12:03 12