Replacing high-mount brake lamp bulb, Replacing license plate lamp bulbs, Replacing fog lamp bulbs – Lincoln 2008 MKZ User Manual

Page 50: Lights

Advertising
background image

Replacing high-mount brake lamp bulb

1. Make sure the ignition control is
in the LOCK (OFF) position.

2. Open the trunk and reach
underneath package tray to locate
lamp assembly.

3. Remove the bulb socket by
rotating it counterclockwise, then
pulling it out of the lamp assembly.

4. Pull the bulb straight from the
socket and push in the new bulb.

5. Install the bulb socket into the lamp assembly by rotating it clockwise.

Replacing license plate lamp bulbs

1. Make sure the headlamp switch is
in the OFF position.

2. Remove the two screws from the
license plate lamp assembly.

3. Remove bulb socket by turning
counterclockwise.

4. Carefully pull the bulb out from
the socket.

Install new bulb(s) in reverse order.

Replacing fog lamp bulbs

1. Make sure the fog lamp switch is
in the OFF position.

2. From underneath the vehicle,
partially remove the tire splash
shield by removing four drive
screws.

After removing to allow free access
to the front fog lamp bulb and
electrical wire harness, the splash shield flap should be able to be
repositioned.

2008 MKZ (378)
Owners Guide (post-2002-fmt)
USA
(fus)

Lights

50

Advertising