Lotus 890 - Manual (Page 57)

Replacing the Keyboard
When you are ready to replace the keyboard,
refer to the illustrations in the previous
section as you follow these steps:
1.
2.
3.
4.
Carefully lift up the keyboard and
position it over the case.
Hold the keyboard at a 45° angle and
align it so that the clips on the bottom
edge fit into the case.
Gently lower the top of the keyboard until
it is securely in place. You should not have
to force it. Make sure the flat cables are
not caught under the edge of the
keyboard.
The top edge of the keyboard should not
overlap the bronze-colored ledge of the
case. If you have difficulty aligning the
keyboard try the following approach
hold the top of the keyboard in the center
with the keyboard at a 45° angle and line
up the clips on the bottom of the keyboard
with the case. Gently lift up the keyboard
until the clips are aligned.
Position the plastic strip above the
keyboard and push it back until it snaps
Into place. The strip fits tightly but should
not obstruct the function keys
5-10 Upgrading Internal Components