Lotus 890 - Manual (Page 64)

7. If you are finished installing internal
components, replace the keyboard as
described under “Replacing the
Keyboard.”
8. Run Setup, as described under
"Customizing Computer Settings” in
Chapter 6, to make sure the port address is
set correctly for the fax/modem or the
Infrared device. The default setting Is
COM2.
For information about using your fax/modem,
see the following section. For more
information on using an infrared device, see
Appendix B in the online manual.
Connecting a Phone Line
You can connect your telephone line directly
to the fax/modem in your ActionNote with a
standard RJ-11 telephone cable.
Before you connect the phone line, you need to
install the software that came with your
fax/
modem. See your software manuals for
Instructions on installing these programs and
using them with your system.
Upgrading Internal Components 5-17