Lowrance electronic LRA-1000 - Manual (Page 13)

7
Section 2: Radar Setup
This section will teach you how to prepare your radar for operation. Be-
fore you begin radar setup, the radar scanning unit, RIM 100 module
and display unit must all be installed and their cables connected. The
display unit must be running software version 1.3.0 or later.
WARNING:
Do NOT attempt to execute Radar Setup, while the ves-
sel is moving. Some motion from wind and wave action is
acceptable, but these setup instructions are NOT in-
tended for vessels moving across the water.
Caution:
If you are unsure or do not understand the following instruc-
tions, it is strongly recommended that an experienced radar
technician handles radar setup and the installation of radar
hardware.
Getting Started
1. After turning on the unit, press
MENU
|
MENU
, then use ↑ ↓ to
S
YSTEM
S
ETUP
and press
ENT
.
Communications Port selected from System Setup menu (left). Com-
munications Port menu (right).
2. From the System Setup menu, highlight
C
OMMUNICATIONS
P
ORT
and
press
ENT
.
3. Press ↓ to
R
ADAR
and press
ENT
, which will place an X in the radar
checkbox. The Baud Rate automatically will switch to 230400. Press
EXIT
repeatedly to return to the main page display.
4. Press
PAGES
, then use ← → to select the radar tab.
5. Press ↓ to select
R
ADAR
O
NLY
, then press
EXIT
.