Lexicon MC-1 - Manual (Page 64)

56
Lexicon
Troubleshooting
Problem Possible Cause and Solution
No Video Make sure that video cables (particularly S-Video cables) are fully
inserted and that the appropriate connector is assigned to the VIDEO IN
parameter in the Input Configuration menu.
Hum Finding and eliminating audio hum in a complex installation can be a
very frustrating task. Often, the easiest way to identify the culprit(s) is to
systematically eliminate devices from the audio chain. If Cable TV is
connected to any component in the system, start by unplugging the
Cable completely, preferably right at the wall jack. If this eliminates, or
greatly reduces the hum, it is worth a call to your Cable company. A quick
fix, assuming your cable is round 75
Ω
wire, is to attach a 75-300
Ω
transformer to the end, then attach a 300-75
Ω
transformer to that, so
that the end is back to a round 75
Ω
wire. There are commercially
available antenna lead isolators which may provide additional insulation
from electrical surges.
Interference with Radio or TV The MC-1 does generate minimal amounts of RF energy and is in
compliance with FCC rules and CE standards. If some interfering noise
is noted, move AM loop and FM "T" type antennas away from the
MC-1
and reorient them as necessary. Use shielded cable for FM and
TV antenna feeds.
Erratic recall of modes Severe power surges or sags can confuse the MC-1 memory. To
correct, or if you simply want to start over, restore the factory defaults
with the procedure described at the end of this section.
If all else fails… Turn off all amplifiers. Turn the master power switch on the MC-1 rear
panel OFF, wait 10 seconds, then turn it ON again. This causes the unit
to run a diagnostic self-test routine which takes a couple of seconds. If
the MC-1 LCD displays normally at the end of this test, no problems have
been found with the MC-1 circuitry. If the internal tests fail, the LCD may
display an error message, or no message at all. If this happens, contact
your dealer or Lexicon Customer Service.
If you find that your custom settings are routinely being corrupted, the
lithium battery in the MC-1
may need replacing. This part is not field-
replaceable — contact your dealer or Lexicon Customer Service.
If the unit is still behaving erratically, perform the Restore Defaults
procedure described on the following page.
Lexicon maintains a knowledge base on its website
(www.lexicon.com) where you can find answers to frequently-asked
questions and additional troubleshooting information.