Landice 8700 - Manual (Page 57)

57
Place the treadmill in Diagnostic Mode:
Display lights up; fails to respond to other buttons.
1. Remove the saftey lanyard.
2. Turnoff the treadmill.
3. Hold the DISPLAY and START key simultaneously and then release
them as soon as the display lights up.
7.1
1. Replace display board. Part # 70076
2. Replace membrane. Part # 70113 (8700),
70111 (8700P) Press each button one at a time. Confirm
that the appropriate code is shown on the
display for each button.
Do all the lights flash on, then off, and then show "PASS" on the display?
Button Code
PROG 1
ENTER 2
PAUSE 4
START 5
DISPLAY 6
FAST 7
SLOW 8
UP 9
DOWN 10
Are ALL codes correct? Replace membrane. Part # 70113 (8700),
70111 (8700P)
7.2
YES NO
NO
Place saftey lanyard in the correct position.
Does code "11" show in the speed display?
Replace display board. Part # 70076
Press OFF to leave Diagnostic Mode.
NO
YES
7.4
7.3