Landice 8700 - Manual (Page 75)

75
MAX MIN IR CL
STEP 2: Turn machine on, increase speed until 1.2 mph
shows on display,
then slowly decrease speed just until
the display shows exactly 1.0 mph.
STEP 3: Adjust "MIN" pot on KBLC-118 until belt
speed is between
0.95 - 1.00 mph using a tachometer OR
8.8 - 9.3 rpm counting belt revolutions.
STEP 4: Turn speed up to 8.8 mph ( on display ),
then slowly increase
speed just until display shows
exactly 9.0 mph.
STEP 5: Adjust "MAX" pot on the KBLC-118 until the belt
speed is between
8.95 - 9.00 mph ( or
83.0 - 83.4 rpm ).
STEP 6: Since the "MAX" and "MIN" pots will affect each
other during the
adjustment, it may be nessary to repeat
steps 2 - 5 several times.
Continue calibration until neither pot
needs readjustment.
Appendix 2: Elevation System Calibration
Note: The elevation system will need to
be re - calibrated:
1. After replacing the elevation
motor.
2. After replacing the elevation
potentiometer.
3. If the elevation readout appears
inaccurate.
STEP
1:
Remove the two screws holding the elevation
potentiometer
and pull the pot from the back of the
elevation motor.
STEP
2:
Turn the treadmill on in the diagnostic
mode by holding down the “ Select