Loewe Viewvision DR+DVB-T - Manual (Page 21)

1 -
Auto Setup
After you have pressed the On/Off button for the first time or reset the device to the
factory settings, the wizard for the automatic setting starts. This sets the language
of the menus and dialogs of the recorder, the time and the stations.
5 6 Select menu Language.
Language
Select the Language.
English
OK Next
Confirm selection with OK.
Check the antenna connection as illustrated.
Antenna
Prev.
Check your antenna connection.
TV
IN (from ANT.)
Antenna
Cable
Wall jack
DVD-
Recorder
OUT (to TV)
OK Next
Continue with OK.
5 6 Set time. Select Auto or Manual.
Confirm selection with OK.
Clock Set
Manual
Next Prev.
Auto
Select a mode.
OK
Auto: The current time and date are set automatically after the
station search (see ”Set time” on page 7).
Manual: Enter the date and time.
3 4 Move cursor.
5 6 Enter data.
Confirm with OK .
5 6 Select country.
4 Press.
5 6 Select Signal Source.
4 Mark Start.
Start station search with OK.
Auto Programming
Start
Signal Source
Select a mode
OK Start
Others
Prev.
DVB-T+Analogue
The receiver runs through all the available analogue and digital
channels automatically and transfers the found stations to the
station list. In the DLP option the station list is transmitted by a
Loewe TV set with Digital Link Plus (page 4).
End
Initial Setup is Completed.
Close Prev. OK
Confirm selection with OK.
Initial Installation