Linn LS500 - Manual (Page 12)

10
GRILLES
To fit the grille, ensure that the shiny side of the material is to the outside.
Find the knotted part of the grille elastic, and locate it in the slot below the
bass driver that separates the top and bottom baffles. Place the knot about a
third of the way in from a corner, then pull the grille up evenly over the
baffle. Then find the joint in the rubber ring and locate it in the slot below the
bottom baffle, again about a third of the way in from a corner. Pull the ring up
so that it locates in the slot on top of the top baffle. A plastic ruler can be
used to encourage the elastic and the rubber ring into the slot.
To remove the grille, grip the top right hand corner, pulling it so that the
rubber ring and elastic clear the baffle. Then remove the ring and the grille cloth.