Line 6 headphones powered monitors - Manual (Page 10)

Line 6 GearBox 3.1 – Basic Features Guide
Note – GearBox will not display this Mute button when PODxt is the source device.
• Pan slider - Pans your source input left or right. This affects the signal that is routed to
BOTH your Record Send 1-2 and the Monitor path. Double click on the slider to set it to dead
center.
For TonePort devices - When using a single Tone Source, these control the Record Send 1-2
Monitor signal path. Send 3-4 has its own set of Monitor controls (accessible in the effects panel
when you click the Send 3-4 icon). If you are in a Dual-Tone Source mode, these controls will
affect the current, visible Tone only.
8 - Out To Hardware controls:
TonePort & GuitarPort -
• Volume knob - controls the level of audio routed out the analog Line Outs (and headphone
out) of your device. This will affect both your Monitor signal AND the playback signal
coming into your Line 6 device from your audio software. It does NOT affect the level of
your signal going to the Record Send 1-2.
• Output Indicator/Clip light - will light up green to indicate your signal, and gets yellow and
then red as the level increases. Red means your signal is too hot and you should reduce all
individual levels and/or the Volume knob.
• Mute Line Out button – Mutes all signals routed to the Line Outs only (and not your
headphone out), but does not affect the signal routed to the Record Sends. This is very useful
when recording with a Mic since it stops your mic signal from coming out your speakers (to
avoid feedback) but still lets your hear it and everything else through your headphones.
Note – GearBox will not display this set of Out To Hardware controls when PODxt is the source
device.
For TonePort/GuitarPort devices – These controls affect the Monitor and playback signal paths
for both Record Sends 1-2 and 3-4, or both Tones when using a Dual-Tone Source.
9 - Bypass button:
TonePort - will bypass all amp and effects processing for the currently displayed Tone. Just your
“naked”, unprocessed signal will be heard as well as routed to your Record Sends when bypassed.
GuitarPort - will bypass all amp and effects processing. Just your “naked”, unprocessed signal will
be heard as well as routed to your Record Sends when bypassed.
PODxt - will bypass only the amp
10 - Tuner button: Toggles the display of the Guitar Tuner.
11&12 - Effects Show/Hide and On/Off toggles:
• Clicking on the top portion of each of the little “stomp box” icons in this row will toggle the
lower Effects Panel to display that effect’s controls. You can do this independently of
Page 10