Lantronix UDS100 - Manual (Page 5)

UDS10/UDS100 User Guide
5
Remote IP Address______________________________________________ 32
Remote Port ___________________________________________________ 32
Disconnect Mode _______________________________________________ 33
Flush Mode ____________________________________________________ 33
Pack Control ___________________________________________________ 34
Disconnect Time (Inactivity Timeout) ________________________________ 35
Send Characters ________________________________________________ 35
Telnet Terminal Type ____________________________________________ 35
Channel (Port) Password _________________________________________ 35
Expert Settings ____________________________________________________ 35
TCP Keepalive time in s __________________________________________ 36
ARP Cache timeout in s __________________________________________ 36
Security Settings ___________________________________________________ 36
Disable SNMP__________________________________________________ 36
SNMP Community Name _________________________________________ 37
Disable Telnet Setup_____________________________________________ 37
Disable TFTP Firmware Upgrade ___________________________________ 37
Disable Port 77FE (Hex) __________________________________________ 37
Disable Web Setup ______________________________________________ 37
Disable ECHO Ports _____________________________________________ 37
Enable Enhanced Password _______________________________________ 37
Factory Default Settings _____________________________________________ 38
Channel 1 Configuration Defaults ___________________________________ 38
Expert Settings Defaults __________________________________________ 38
Security Settings Defaults _________________________________________ 38
Exit Configuration Mode _____________________________________________ 38
6: Updating Firmware 39
Obtaining Firmware _________________________________________________ 39
Reloading Firmware ________________________________________________ 39
Using DeviceInstaller ____________________________________________ 39
Using TFTP____________________________________________________ 40
Using Another Unit ______________________________________________ 41
Using the Serial Port _____________________________________________ 41
7: Using Monitor Mode 43
Entering Monitor Mode Using the Serial Port _____________________________ 43
Entering Monitor Mode Using the Network _______________________________ 43
Using Monitor Mode Commands _______________________________________ 44
8: Troubleshooting and Contact Information 45
LEDs ____________________________________________________________ 45
Problems and Error Messages ________________________________________ 46
Technical Support __________________________________________________ 49
9: Connections and Pinouts 51
Serial Port _____________________________________________________ 51
Serial Connector Pinouts _________________________________________ 51
Null-Modem Cable ______________________________________________ 53