Using a telnet connection, Figure 5-1. network login using telnet, Configuring – Lantronix UDS100 User Manual
Page 22: The uds using telnet or the serial port
22
5
5
:
:
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
i
i
n
n
g
g
t
t
h
h
e
e
U
U
D
D
S
S
U
U
s
s
i
i
n
n
g
g
T
T
e
e
l
l
n
n
e
e
t
t
o
o
r
r
t
t
h
h
e
e
S
S
e
e
r
r
i
i
a
a
l
l
P
P
o
o
r
r
t
t
You must configure the UDS so that it can communicate on a network with your serial
device. For example, you must set the way the unit will respond to serial and network
traffic, how it will handle serial packets, and when to start or close a connection.
As an alternative to using Web Manager, configure the UDS using a series of
prompts referred to as Setup Mode, accessed using a Telnet or a serial port
connection. Once you access the screen, the configuration procedure is identical.
The unit’s configuration is stored in nonvolatile memory (NVRam) and is retained
without power. You can change the configuration at any time. The unit performs a
reset after the configuration has been changed and stored.
This chapter provides instructions on using Setup Mode and detailed explanations of
the configuration settings.
Using a Telnet Connection
To configure the unit over the network, establish a Telnet connection to port 9999.
Note:
You can also establish a Telnet connection by clicking the Telnet icon
on the DeviceInstaller “Manage List” window (see
1. On the Windows Start menu, click Run and type the following command, where
x.x.x.x is the IP address and 9999 is the unit’s fixed network configuration port
number.
Figure 5-1. Network Login Using Telnet
telnet x.x.x.x 9999
Note:
Be sure to include a space between the IP address and 9999.
2. Click
OK
. To remain in Setup Mode, you must press Enter within 5 seconds.
The current configuration settings display, followed by the Change Setup menu.