Using monitor mode, Entering monitor mode using the serial port, Entering monitor mode using the network – Lantronix UDS100 User Manual
Page 43: Entering monitor mode using the, Serial port
43
7
7
:
:
U
U
s
s
i
i
n
n
g
g
M
M
o
o
n
n
i
i
t
t
o
o
r
r
M
M
o
o
d
d
e
e
Monitor Mode is a command line interface used for diagnostic purposes. There are
two ways to enter Monitor Mode: locally using the serial port or remotely using the
network.
Entering Monitor Mode Using the Serial Port
To enter Monitor Mode locally, follow the same principles used in setting the serial
configuration settings:
1. Do one of the following:
To enter Monitor Mode with network connections, type xx1 or zzz (not three
x keys as you did before).
To enter Monitor Mode without network connections, type xx2 or yyy.
A 0> prompt indicates that you have successfully entered Monitor Mode.
Entering Monitor Mode Using the Network
To enter Monitor Mode using a Telnet connection:
1. First establish a Telnet session. The following message displays:
Figure 7-1. Entering Monitor Mode Using the Network
2. Type
M
(upper case).
A 0> prompt indicates that you have successfully entered Monitor Mode.