Light & Motion BLUEFIN HC7 - Manual (Page 18)

16
Bluefin Monitors - Getting Started
Illustrated below are the components of the Compact Monitor and the Remote
Monitor. Take time to identify and become familiar with each part.
Compact Monitor
Remote Monitor
Bulkhead
Clamp Assembly
Monitor Cable
Lens Shade
Bluefin Monitor - Bulkhead Installation
1. Remove the Rear Plate.
2. Using a flat head screwdriver or coin, remove the Port Plug (Refer Fig. 20).
3. On the inside of the Rear Plate, remove the four screws using a 3/32 Allen key and remove
circuit board (Refer Fig. 21).
4. Feed Bulk Head cable through Bulk Head port (Refer Fig. 22).
5. Insert Bulk Head into Rear Plate until it is firmly seated.
6. Tightening bulk head by turning the bulk head itself with a 3/4” wrench.
7. Attach Bulk Head Cable into the Primary Bulkhead connector on the inside of the Rear
Plate circuit board.
8. Replace circuit board and secure it to the Rear Plate using the four button head cap
screws.