Light & Motion BLUEFIN HC7 - Manual (Page 20)

18
Remote Monitor Operation
1. If necessary, provide power to the monitor by positioning the appropriate bulkhead switch,
to the ON position. The switch is located on the inside of the Rear Plate.
2. Connect monitor cable to Bulkhead prior to entering the water.
3. Connect monitor cable to Remote Monitor prior to entering the water.
4. Station the BlueFin housing in the area you are going to shoot.
5. Gently let out the slack in the cable as you move the viewing location.
6. Operation of Controls:
Left Side (Refer Fig. 18)
L. Light - Operates left video light.
R. Light - Operates right video light.
Bright - Adjust brightness of monitor.
Far - Moves focus point further from camcorder.
Close - Moves focus point closer to camcorder.
Right Side (Refer Fig. 19)
Af/Off
AF - Press once to return camcorder to auto focus from manual focus.
OFF - Turns camcorder off. Press and hold for three seconds then release.
Rec - Toggles between record and stand-by modes.
Mom.Af - Pressing and holding this button puts the camcorder into “Momentary
AF”. Camcorder remains in AF as long as the button is pressed. Once
released, the camcorder switches to manual focus. This is useful in stopping the
camcorder from “seeking” when shooting in a low contrast environment. To
return the camcorder to AF, press the AF/OFF button.
Tele- Zooms camera to telephoto.
Wide - Zooms camera to wide angle.
Power On/Off with Remote Monitor
On - When camcorder is in a powered down state, press any button on the Remote
Monitor EXCEPT BRIGHT to return camcorder to powered up state and
activate the Remote Monitor LCD screen.
Off - Press and hold AF / OFF button for three seconds.