Light & Motion BLUEFIN HC7 - Manual (Page 25)

Removing Batteries
1. Rotate latch at the front of the pod counter-clockwise 1/8 turn, until it stops.
2. Pull the front cap off the pod.
3. Pull the battery from the pod using removal strap.
Mounting Battery Pods
1. Remove the rear plate of the housing.
2. Slide the battery pods into housing channels.
3. Insert Pod Locker between the pods and tighten using 1/8” Allen key.
Do not over-tighten.
Connecting Lights to Battery Pods
1. Plug in the cable connectors on the pod.
2. Tighten the locking sleeves by rotating clockwise until tight.
3. Plug in the cable connectors on the Light Head. (Pro Lights only)
4. Tighten the locking sleeves by rotating clockwise until tight.
Light Operation
Confirm that the mode selector (flat position of bezel around power button) is set to the P
setting for Pro or Mini Pro Lights or E for Mini Elite Lights (Refer Fig 27).
Operation from Smart Grips
1. Activate initial power-up by pressing the Pod Power Button (Refer Fig 27).
After initial power-up lights may be controlled using LIGHT button on the left Smart Grip.
2. Turn off lights by pressing and holding the LIGHT button.
Operation from Battery Pods
1. Turn on light by pressing the Power Button on the rear cap.
2. Turn off light by pressing and holding the Power Button on the rear cap.
23