Linear HTS-ES1 - Manual (Page 24)

USB Input
ENTER
MENU
USB MIC VOL 1 MIC 1
BAND
OPEN/
CLOSE
MODE SCAN
MUTE MIC
®
EQ
Selecting USB Audio Play Source:
To select a USB play source, press the MODE but-
ton until “dISC” appears in the display. Insert the
USB connector from the player into the HTS-ES1’s
USB jack. The audio from the player can now be
heard through the speakers. Use the HTS-ES1’s
controls to select the desired file to play.
Disc File Selection:
Press the button to select a lower file num-
ber. Press the button to select a higher file
number. The file number will appear in the dis-
play.
Files can also be selected by using the remote
control. Press the file selection number that cor-
responds to the file you want to play, then press
the ENTER button.
For example: If you want to play file 8, press but-
ton 8, then the ENTER button.
If you want to play file 12, press 10+ button
once, immediately followed by pressing button
2, and then press the ENTER button. File 12 will
start playing and 12 will appear in the display.
Note: To select a file in the twenties, press the
10+ twice, immediately followed by pressing the
button that corresponds to the second digit.
MIC VOL 2 MIC 2 ECHO AUX IN
SPEAKERS A B A+B
Down Up
VOLUME +
MP3
File Elapse Time
AUDIO
ENTER
+
AS/PS
ELAPSE
BAND EQ SUB.TT
MENU 1 2 3
5 6 7 4
9 10/0 10 + 8
SLOW
File Selection
Numbers
(Buttons 1-10+)
Pausing Playback:
Press the button to pause play. Press it
again to resume play.
MIC VOL 2 MIC 2 ECHO AUX IN
SPEAKERS A B A+B
VOLUME +
Stopping Playback:
Press the button to stop the playback.
“STOP” will appear in the display. Press the
button to start playing the disc from where it
was playing before stopped.
Press the button 2 times. Then press
the button, and the disc will start playing
from the beginning.
VOLUME +
MIC VOL 2 MIC 2 ECHO AUX IN
SPEAKERS A B A+B
24
HTS-ES1-UM1 (First Lot).qxp 2/7/08 2:29 PM Page 24