Lyngdorf Audio DPA-1 - Manual (Page 35)

3 5
Technical Specifi cations
Audio
Parameter Value Note
Balanced input connectors 3 pin XLR, gold-plated. Case=Gnd, Pin1=Gnd,
Pin2=Hot(+), Pin3=Cold(-)
Balanced input impedance 10KOhm AC-coupled.
Unbalanced input connectors RCA (phono) jack, gold-plated. Case=Gnd, Tip=Hot(+)
Unbalanced input impedance 10KOhm AC-coupled
DAC Out impedance 50Ohm Gain According to volume con-
trol setting. 88 dB = 0 dB with
sensitivity normal and rel.
volume 0 dB
Input sensitivity 4.4V (2.2V with high sens.)
Unbalanced output 4.4Vrms
Balanced output 8.8Vrms
Frequency Response 20 - 20KHz +/-0.1dB RoomPerfect Highpass Filter
-3dB at 18Hz
THD+N A-wgt
Digital to Analog
-103dB Neutral voicing - ref 4.4V
S/N Ratio
Digital to Analog
-113dB Neutral voicing - ref 4.4V
Dynamic Range
Digital to Analog
-113dB Neutral voicing - ref 4.4V
THD+N A-wgt
Analog to Digital
-110dB Neutral voicing - ref 4.4V
S/N Ratio
Analog to Digital
-119dB Neutral voicing - ref 4.4V
Dynamic Range
Analog to Digital
-119dB Neutral voicing - ref 4.4V
THD+N A-wgt
Analog to Analog
-103dB Neutral voicing - ref 4.4V
S/N Ratio
Analog to Analog
-113dB Neutral voicing - ref 4.4V
Dynamic Range
Analog to Analog
-113dB Neutral voicing - ref 4.4V
Channel Separation -114dB AC Sweep from 125 - 16KHz
All audio measurements, except frequency response, are measured with a 20KHz low-pass fi lter in
accordance with AES-17.