Lyngdorf Audio DPA-1 - Manual (Page 9)

9
5. 115V and 230V Mains Voltage Switch.
Switches between 115V and 230V mains input voltage.
Make sure the rear selector is in the correct setting and connect the power input
only to the appropiate AC source. The warranty will not cover any damage caused
by connecting to the wrong type of AC mains.
6. Digital Input 1-3
RCA connectors for SPDIF input
7. Digital Output
The digital output can be selected as the main or the line channel. In both cases the output can be se-
lected as Full Scale or Regulated.
The sample rate is fi xed at 96 kHz. This output is also active when Analog input is selected.
8. Digital Input 4
XLR Connector for AES input
9. Optical Digital Input 5
Connector for Toslink input
10. Mic. In
Mic. in for connection of RoomPerfect™ microphone.
11. Trigger Out
DC Trigger out for remote start of SDA 2175, power amplifi ers or other suitable equipment with a remote
start.
The output voltage is 12V and a maximum current of 50mA can be drawn from the output.
12. RS232 Input/Aux
RS232 communication connectors for communication with a PC, remote control from other Lyngdorf
equipment with broadcast commands or linked control between several other amplifi ers or other suitable
equipment with a remote start.
The ‘INPUT’ is used for connection to a PC, or as a control input from a Lyngdorf master amplifi er.
The ‘AUX’ connection is output in Master mode for controlling slave amplifi ers, or bypasses input
from other master amplifi ers to the next amplifi er.
13. Mains Input
•
•