Regulatory information, Safety warning statement, California lead warning statement – Linksys Player / Wireless-N Music Extender DMP100 User Manual

Page 46: Fcc rf exposure statement, Canadian rf exposure statement, Australian rf exposure statement, Approved antenna information, Fcc part15 class b statement, Fcc caution, Wireless home audio

Advertising
background image

Regulatory Information

39

Wireless Home Audio

Player/Wireless-N Music Extender

Regulatory Information

Safety Warning Statement

WARNING:

This

exclamation

point

indicates that there is a caution or

warning of potential risk of bodily injury

and/or it is something that could damage your

property or product.

WARNING:

Do not use this product near water,

for example, near bath tube, kitchen sink, in a

wet basement or near a swimming pool.

California Lead Warning Statement

WARNING:

This product contains lead, known

to the State of California to cause cancer, and

birth defects or other reproductive harm. Wash

hands after handling.

FCC RF Exposure Statement

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. This

equipment should be installed and operated with

minimum distance 20 cm between the radiator and your

body. This transmitter must not be co-located or operating

in conjunction with any other antenna.

Canadian RF Exposure Statement

This equipment is in conformity with the IC radiation

exposure limits set forth for an uncontrolled environment.

This device must be installed and used at a distance of at

least 20 cm (8 in) between the antenna and the body of

the user. The transmitter should not be placed close to

another antenna or another transmitter, or to function

with another antenna or another transmitter.

Avis d’Industrie Canada concernant

l’exposition aux radiofréquences

Cet appareil numérique est conforme aux limites établies

par IC en matière d’exposition aux radiofréquences dans

un environnement non contrôlé. Ce matériel doit être

installé et utilisé à une distance d’au moins 20 cm (8 in)

entre l’antenne et le corps de l’utilisateur. L’émetteur ne

doit pas être placé près d’une autre antenne ou d’un autre

émetteur, ou fonctionner avec une autre antenne ou un

autre émetteur.

Australian RF Exposure Statement

WARNING:

To ensure compliance with exposure

limits to radiofrequency fields, the antenna of

the device should be no closer than 20 cm from

the body during use.

Approved Antenna Information

DMP100 player with Dipole type antenna and maximum

antenna gain is 3.5dBi in 5 GHz band and 1.5dBi in 2.4GHz

band.

FCC Part15 Class B Statement

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.
This product has been tested and complies with the

specifications for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in

a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not

installed and used according to the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception,

which is found by turning the equipment off and on, the

user is encouraged to try to correct the interference by

one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or

devices
Connect the equipment to an outlet other than the

receiver’s
Consult a dealer or an experienced radio/TV technician

for assistance

FCC Caution

Any changes or modifications not expressly approved by

the party responsible for compliance could void the user’s

authority to operate this equipment.
For operation within 5.150-5.250 GHz frequency range, it

is restricted to indoor environment.
The availability of some specific and/or operational

frequency bands are country dependent and are firmware

programmed at the factory to match the intended

destination. The firmware setting is not accessible by the

end user.

Advertising