Linksys Player / Wireless-N Music Extender DMP100 - Manual (Page 47)

Regulatory Information
40
Wireless Home Audio
Player/Wireless-N Music Extender
IC Class B Statement (Canada)
This class B digital device complies with Industry Canada
ICES-003 and RSS-210 rules.
Operation is subject to the following two conditions
This device may not cause interference and 1.
This device must accept any interference, including 2.
interference that may cause undesired operation of
the device
This device has been designed to operate with an antenna
having a maximum gain of 3.5dBi. Antenna having a higher
gain is strictly prohibited per regulations of Industry
Canada. The required antenna impedance is 50 ohms.
Règlement de la classe B d’Industrie
Canada
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 et RSS-210 d’industrie.
L’opération est sujette aux deux conditions suivantes :
Ceci le dispositif peut ne pas causer l’interférence et 1.
Ceci le dispositif doit accepter n’importe quelle 2.
interférence, y compris l’interférence qui peut causer
fonctionnement peu désiré du dispositif.
Ce dispositif a été conçu pour fonctionner avec une
antenne ayant un gain maximum du dBi 3.5 L’antenne
ayant un gain plus élevé est strictement interdite par
règlements d’industrie Canada. L’impédance exigée
d’antenne est de 50 ohms.
Industry Canada Interference
Statement
The device for the band 5150-5250 MHz is only for indoor
usage to reduce potential for harmful interference to co-
channel mobile satellite systems;
The maximum antenna gain 3.5dBi permitted (for devices
in the band 5250 - 5350 MHz and 5470 - 5725 MHz ) to
comply with the e.i.r.p. limit ; and the maximum antenna
gain 3dBi permitted (for devices in the band 5725-5825
MHz) to comply with the e.i.r.p. limits specified for point-
to-point and non point-to-point operation as appropriate,
as stated in section A9.2(3).
The DMP100 Player has disabled the 5600-5650M band by
S/W to avoid 5600-5650M band for IC certification.
WARNING: In addition, users should also be
cautioned to take note that high-power radars
are allocated as primary users (meaning they
have priority) of the bands 5250-5350 MHz and
5650-5850 MHz and these radars could cause
interference and/or damage to LE-LAN device.
CE – Marking
CE marking on this product represents the product is in
compliance with all directives that are applicable to it.
EU Declaration of conformity (DOC)
This product complies with the essential requirements of
the EMC Directive 2004/108/EC, the Low Voltage Directive
2006/95/EC and the R&TTE Directive 1999/5/EC. For more
detail, Please see the DoC.
NOTE: For all Cisco-Linksys products, the
Declaration of Conformity (DoC) is available in
one or more of the following options:
A PDF file is included on the product’s CD. •
A printed copy is included with the product. •
A PDF file is available on the product’s webpage. Please •
visit www.linksysbycisco.com/international and select
your country region. Then select your product model.
R&TTE Declaration of Conformity
This device complies with the essential requirements of
the R&TTE Directive 1999/5/EC. Compliance Information
for 2.4-GHz and 5-GHz Wireless Products Relevant to the
EU and Other Countries Following the EU Directive1999/5/
EC (R&TTE Directive).The following standards were
applied during the assessment of the product against the
requirements of the R&TTE Directive:
Radio: EN 300 328 (2.4GHz), EN 301 893 (5.0GHz) •
EMC: EN 301 489-1, EN 301 489-17 •
Safety & Health: EN 60065 and either EN 50385 or EN •
50371 if applicable