Lopi Answer Wood Stove - Manual (Page 45)

Optional Equipment 45
© Travis Industries 100-01166 4040907
2. Adjust the position of the side panels so they are: 1) flush with the bottom of the insert; 2) both the
same distance back from the front of the insert; 3) perpendicular to the floor (use the top panel, if
necessary, to judge alignment). Tighten the screws that hold the side panels in place.
3. Place the insert into the fireplace and connect the flue (if using a positive or direct connection). Install
the top panel and trim following the directions below.
Install the top panel so the two
tabs insert into the joggle clips on
the top panel.
Top
Panel
"L" Bracket
Double-Back
Tape
Right
Side
Trim
Construct the panel trim. Insert one leg of
each "L" bracket into the top and side trim
piece. Align the trim to form a precise corner,
then tighten the two set screws with a small
standard screwdriver. Slide the trim over the
panels. Attach a piece of included double-
back tape to the bottom of each side trim to
keep it from flaring at the bottom.
Tighten the set screws from the
back side with a small standard
screwdriver
"L" Bracket
Right Side
Trim
Top Trim
b
a
Top Trim
Insulation Installation (required only for face seal installations)
1. With the insert drawn 6" from the fireplace, glue the insulation strip included with the insert to the back
of the panels using RTV silicon or stove gasket cement. The insulation should be installed so it
overlaps the fireplace opening to form a seal between the panels and the fireplace face. Let the
silicon or cement dry.
2. Push the insert into the fireplace, allowing the insulation to form a seal between the panels and the
fireplace. Use a screwdriver to tuck any exposed insulation behind the panels.