Lenoxx Electronics CI2000HT - Manual (Page 15)

CARE AND OPERATION
PAGE 15
PRIMARY AIR DRAFT CONTROL
Use the air control adjustment tool (provided) to adjust
the air controls per the following instructions.
Air Control / Ash Pan Removal Tool
The primary combustion air delivery is controlled by the
Primary Air Draft Control Assembly (located above the
front door). The heat output can be controlled by sliding
the control to a higher or lower heat output setting using
the Air Control Tool Provided (See Primary Air Draft Con-
trol below).
The fuel, the amount of heat and burn times desired, the
type of installation are all variables that will affect the
control setting. The same control settings in a variety of
installations will produce different results. You will need
to try different settings so you can learn how much heat
to expect and how long the fire will burn.
With the air control tool (provided in accessory package)
the control can be adjusted to the heat output desired
(see following illustration).
Primary Air Draft Control
Using the air control tool (provided) slide the control
above door to adjust burn rate.
Adjusting Burn Rate:
The primary air draft control located above the front door
can be adjusted to the right for higher temperatures and
to the left for lower temperatures.
Generally, you will want to set the draft control some-
where in the low or medium range
Tips - Adjust the primary air control to a medium to
low setting for a slow and more efficient burn. When
burning on a higher setting, it is more efficient to
burn with a bright but not roaring fire.
START UP AIR CONTROL (IGNITION BOOSTER)
To facilitate lighting, your stove is equipped with an igni-
tion booster, which brings start-up air to the fire for a
short period of time. This can be especially helpful when
your chimney is cold. The ignition booster can also be
used to allow the fire to recover quickly following refuel-
ling.
Start-Up Air Control
PROVIDES SUPPLEMENTAL PRIMARY AIR. DO NOT
LEAVE THE START-UP AIR CONTROL OPEN FOR MORE
THAN FIVE MINUTES.
Before Initial Lighting
1. Using the air control tool open the start-up air control
by pulling the lever outwards (see illustration above).
2. Load fuel into the firebox and light the fire as usual
(see How To Start And Maintain A Fire on page 16)
DO NOT LEAVE THE START-UP AIR CONTOL IN THE
OPEN POSITION FOR MORE THAN FIVE MINUTES
(THIS COULD RESULT IN DANGEROUS OVERFIRING
WHICH IS NOT COVERED UNDER THE WARRANTY).
CLOSE BY PUSHING THE LEVER INWARDS.
See How to Start And Maintain A Fire on page 16
Lower Burn / Slide Left
Higher Burn / Slide Right
Start-Up Air
Control Module.
Slide
to
Open
Stove
Back