Lincoln Electric IDEALARC SP-255 - Manual (Page 31)

C-3 ACCESSORIES
IDEALARC SP-255
memory 4 is recalled and appears on the
display. This whole cycle is repeatable as
long as the unit remains in Toggle mode.
DISABLING SPOOL GUN
When the Spool Gun Adapter box transfer
switch is set to FEEDER Gun position, the
display will flash between these two mes-
sages:
Pressing the Process key will return you to
the last process entered before the Spool
gun was attached.
TYPICAL STITCH KEY PRESS
SEQUENCE
Spool screen is displayed prior to pressing
Stitch key. Stitch key is pressed, Stitch
timers are activated and the display
changes to Stitch screen. Stitch ON and
OFF timers can now be adjusted using the
center and right arrow keys. Once the
timers have been set, pressing the Stitch
key again returns the display to the original
Spool screen with the Stitch timer status
indicated in the bottom left corner.
TOGGLE KEY
The first time this key is pressed it turns on
toggle mode and recalls the setup in memo-
ry 4. This mode allows you to toggle
between the setups in memory 4 and mem-
ory 5. Each time the key is pressed, it alter-
nates between the two memories. The tog-
gle screen displays the memory number the
current setup was recalled from, indicates
spool (SPOL:) mode, displays percentage
of wire feed speed, and set arc voltage. The
cursor underlines the memory number cur-
rently selected.
TYPICAL TOGGLE KEY PRESS
SEQUENCE
Spool screen is displayed prior to pressing
Toggle key. Toggle key is pressed, memory
4 is recalled and appears on the display.
The unit is now in toggle mode. Pressing
the Toggle key again “toggles” the unit, and